noob - measurement question
#1
noob - measurement question
First post on this forum, hope someone will humor an odd question:
What's the measurement, flange-to-flange, between front and rear half shafts of a B7 Avant? That is, the flange-to-flange of front and rear diffs.
Don't have one of my own (yet) to measure for myself. I've been trying to get an answer to this question, but am tired of searching for such an obscure nugget of data.
Thanks for your support.
What's the measurement, flange-to-flange, between front and rear half shafts of a B7 Avant? That is, the flange-to-flange of front and rear diffs.
Don't have one of my own (yet) to measure for myself. I've been trying to get an answer to this question, but am tired of searching for such an obscure nugget of data.
Thanks for your support.
#2
Not sure from flange to flange, but from center of axle to axle it's 2648mm the same as the sedan. As a matter of fact wheel bases are the same as well. Nose to rear bumper is all the same.
#3
Thanks, dolamite.
I'm trying to get a sense of the diff width, you know, just in case I want to switch something else in its place. I'm sure I'll have to get custom half shafts, just curious what the 'standard' unit width is.
I'm trying to get a sense of the diff width, you know, just in case I want to switch something else in its place. I'm sure I'll have to get custom half shafts, just curious what the 'standard' unit width is.
Thread
Thread Starter
Forum
Replies
Last Post
quattromano
Audi 90 / 80 / Coupe quattro / Cabriolet
1
11-03-2003 01:26 PM
Gordon Martin
A4 (B5 Platform) Discussion
1
12-01-1999 07:55 PM