kapitango

Hi everybody. Please excuse me for a language errors- I'm from Bulgaria.
I have that problem:
I bought a new instrument panel with auto check and computer for my A6/C4 2,6 Quatrro, I connected it and it works correctly.This new instrument panel has clock on the one place of three gauges, that clock I don't like. On my old instrument panel I had digital clock on the tachometer, Oil Pressure gauge & Oil temperature gauge & gauge Amp. I place these three gauges and the digital clock with the tachometer on my new instrument panel. The three gauges and the tachometer works correctly but the digital clock not working.
There was holes to grow the display of the digital clock On the board(plate) of new instrument panel with auto check and computer and there is and contacts for digital clock too.
I trace the paths on the plate and they are not break.I mark Contacts 2 ,3, 4, 6, 7, 8 & 9 are connected to
MB88636B Chip. Contacts 1, 5, 10 & 11 are connected wit Contacts on the other km.display.





I found place and make a bridge fo swich on the light under the digital clock. Is it posible to make this digital clock to work on this instrument panel with auto check and computer?
Thanks in advance.

kapitango

I forgot this picture:

Giacomino

Hello, did you solve this problem? How could you make digital clock work?