A3 3.2l brake master - Help!
#1
A3 3.2l brake master - Help!
OK, went to service the brake system, pressured all the brake fluid out with a Motive bleeder and now am unable to get all the air out. I cycled the ABS with the Vag-Com three times and still cannot get all the air out of the system, pedal goes to the floor.
From all the posts read, my guess is that the master cylinder seals were rolled, rendering it useless and the cause of my inability to get all the air out. I can accept that.
I have since ordered two MC's online and both (Centric 130.33121 & 130.133125) did not fit. Apparently none of the aftermarket units are made for my car (2007 A3 3.2l quattro), how hard could it be?
Is my only solution to go to my dealer for a replacement? Any help here is greatly appreciated...gotta get back on the road!
From all the posts read, my guess is that the master cylinder seals were rolled, rendering it useless and the cause of my inability to get all the air out. I can accept that.
I have since ordered two MC's online and both (Centric 130.33121 & 130.133125) did not fit. Apparently none of the aftermarket units are made for my car (2007 A3 3.2l quattro), how hard could it be?
Is my only solution to go to my dealer for a replacement? Any help here is greatly appreciated...gotta get back on the road!
Thread
Thread Starter
Forum
Replies
Last Post
Redneck Truck
A6 / S6 (C5 Platform) Discussion
2
11-21-2010 04:27 AM
brat2.ua
A6 / S6 (C5 Platform) Discussion
11
02-03-2008 11:13 PM