pearl2k

I'm also getting the "request sequence error"

audisession

Hi folks - I'm getting the same error - I have the latest VCDS - on a 2013 S4... "request sequence error"

HyperS4

You cant do this on an S4.

audisession

Sorry, typo! I meant to say 2013 S8...

HyperS4

Then you are missing a step. Are you sure you cleared all the previous settings and redid the adaption?

audisession

Ok will check again
Btw all four of my height readings are different - do I add 10mm to each corner or do I force them to be the same

HyperS4

Everyone will get different numbers on each corner. Just add 10 to each corner.

audisession

Thank you - I had skipped the clearing previous reading and redoing adaptation.

I tried it again step by step and it worked!
Added 10mm to each side

Collak

Worked for me, did 15mm. But problem is that default were same by sides, not front/rear.
Left rear and front rear are same, right rear and right front, is this good or it should be same with same front and same rear?

Collak

Hope you see the difference.
Lowered down on 415/411
Lifted up to normal 386/382