Mister Bally

No.

Derekm803

so, how do i know for sure that it is bad?

Derekm803

It was a fuse. I checked all the fuses i thought were relevant before. Must have been looking at the fuse guide wrong or something. I pulled the ccm out and looked at it. It appeared geat. No corroded pins on the plugs and the circuit board looked new on the inside. So, when i went to put it back in i took the meter n pulled every fuse one by one. Found 3 that were bad. Replaced them, put the module back in and voila! $1000+ saved.

bailee

Could you email a pic of the fuses you replaced. My manual had me check two but not I'm thinking I could have missed one/some.
bailee2@charter. net