martP

Howdy
I've recently had a dpf and all its sensors replaced.
Less than a week later the dpf regen light came on so I took it for a spin and cleared it. (A bit premature for a new dpf)

I hooked up my vagcom and checked the measured/calculated soot mass
Calculated= 33g
Measured= 0.75g

It seems the garage never let the ECU know it had new parts so I'm guessing the calculated is continuing from its previous figure before dpf replacement.

Is it possible to reset the calculation with vcds and my vagcom cable?
If so , how?

Thanks in advance
Great looking forum

martP

Forgot to mention its on an Audi a5 3ltr