Dr. Jitter

I have an Audi A8, 2004 with 4.0 TDI engine. I need to oil rod linkages for turbocharger. But i can't translate this instruction for VAS 5051 to my VAG-COM. Could you explain me which address is needed. Of cource, I can't see turbochargers control units as a separate addreses in control module finder.

" - Connect the vehicle diagnostic, testing and
information system -VAS 5051-.
- Carry out the following steps, one after the
other.
Guided Fault Finding/ Guided Functions
Go to - Function and component selection
Powertrain (Repair group 01: 10-39)
ASE engine (Repair group 01: 10-28)
01 Systems supporting self-diagnosis
01 Diesel direct injection and glow plug
system EDC 16C
Electrical components
J 724 Turbocharger 1 control unit
and
J 725 Turbocharger 2 control unit
- Perform a final control diagnosis of
turbocharger control units for about 30
seconds.
- Spray both rod linkages for turbocharger
with spray-on grease -G 055 112 A2- at
points marked by arrows in the previous
illustrations.
- Reassemble both air cleaner housings and
engine cover panel taken off previously in
reverse order. "

Uwe@Ross-Tech.com

Will post what we find.

-Uwe-

Theresias

You mean "final control diagnosis"? Should be output test.