Cylinder specification, tolerances
#1
AudiWorld Senior Member
Thread Starter
Cylinder specification, tolerances
I want to rebuild my 1.8T (AEB) block.
What are the tolerances and specifications for the cylinder bore?
I assume:
- diameter
- ovality (?)
I want to determine if the block(s) I have are suitable for rebuild.
Planning to run stock rods (Mahle), new rings. Have Scat rods on hand.
What are the tolerances and specifications for the cylinder bore?
I assume:
- diameter
- ovality (?)
I want to determine if the block(s) I have are suitable for rebuild.
Planning to run stock rods (Mahle), new rings. Have Scat rods on hand.
Thread
Thread Starter
Forum
Replies
Last Post
Just Gizmo
A4 (B5 Platform) Discussion
0
03-19-2002 04:50 AM