Davor_

Can someone help me figure this out?
I just got a Vagcom/ross-tech cable and before doing some coding i scaned for codes i guess and this is what i got!
The car is 2012 A6 3.0T (CPO) with Chipwerke and Injen intake!

first code:
9779 - Boost pressure
P0235 00 [096] Regulation range not reached

Second:
6307 MAP/MAF Throttle position Correlation
P0068 00 [101]
(From what i understand our cars don't have MAF sensors)

Three:
721152 - Brake oad replacement mode active
C1011 00 [000]

I had my rear pads replaced by a indie shop that's very popular in the area they service Exotics and high end cars (and my pos) so i guess they screwed up and "left" it in replacement mode?? I'd just like to know what does this affect my car cause I'm going to the shop for service!

I'm not expecting online diagnosis of my car of to fix it over the keyboard but I'd like to know what's going on with my car!

Thank in advance.

blackc7a6

I would disconnect your CW then clear codes and drive it hard to see if the codes come back. Also at the same time disable replacement mode.

Audi A6 (4G/4H) Parking Brake - Ross-Tech Wiki

Davor_

Thank you I will try that is it weird that there is no light on the dash and yet I have the error for rear brakes?