Failed crank pulley, service position anyone?
#1
Failed crank pulley, service position anyone?
A6C7, 3.0t, stock, 173k miles...
Hey guys, so my crank pulley fail and it took out both belts and looks like one of the tensioners too...
Now I'm in a search of service position for my POS Audi but I can't find anything... Is there anyone who knows how to do it or have some kind of DIY?
thanks a lot...
Hey guys, so my crank pulley fail and it took out both belts and looks like one of the tensioners too...
Now I'm in a search of service position for my POS Audi but I can't find anything... Is there anyone who knows how to do it or have some kind of DIY?
thanks a lot...
#2
AudiWorld Member
I used this PDF pulley removal instructions to get my car in the service position. It is instructions for an Audi S4 3,0t, but was almost identical to my A6C7.
Some people have had failures with the ACC not working after performing this. I had no issues.
Check out some of @IknowHuhA6 post for front end removal.
https://www.audiworld.com/forums/a6-...apart-2890371/
Some people have had failures with the ACC not working after performing this. I had no issues.
Check out some of @IknowHuhA6 post for front end removal.
https://www.audiworld.com/forums/a6-...apart-2890371/
Last edited by engleg; 06-24-2017 at 11:49 AM.
#4
AudiWorld Senior Member
Here's another useful post about service position from another fellow gearhead. = )
Earlier platform, but same engine.
https://www.audiworld.com/forums/a6-...ulley-2884201/
Earlier platform, but same engine.
https://www.audiworld.com/forums/a6-...ulley-2884201/
Thread
Thread Starter
Forum
Replies
Last Post
Matthew F
A6 / S6 (C6 Platform) Discussion
16
05-23-2011 10:55 AM
VenTTed
TT (Mk1) Discussion
0
12-06-2002 06:05 AM