Remove panels
#2
#4
#5
AudiWorld Senior Member
Driver's knee bolster. 5 allen screws, two at the bottom (one in either corner) and 3 at the top behind the rectangular shaped covers - two behind the wide cover on the left, one behind the smaller cover on the right. A trim tool from the bottom will pop both of these covers right off. Once the bolster cover is free, simultaneously press the three prongs on the OBD2 connector inward toward the wires and the connector will slip right out.
regards,
Brian C.
regards,
Brian C.
Thread
Thread Starter
Forum
Replies
Last Post
uble1234
A6 / S6 (C6 Platform) Discussion
14
10-23-2020 08:07 PM
craigandjenn4
Q5/SQ5 MKI (8R) Discussion
4
09-27-2015 01:57 PM