cyrus89

my left parking brake was operating but not realising, when somebody pulled the switch I had o manually press the cylinder back. Now I but it on a jacked mode and a car stayed on place a week and my battery got emty ( because my rear suspension I dont know which one is leaking drained my battery because the compressor was running ). I started my audi and drove until my battery was full and pulled the parking brake switch and dashboard went red, all breaking lamps were lighting and vagcom says:
02432 - Supply Voltage for Left Parking Brake Motor (V282)
012 - Electrical Fault in Circuit - MIL ON
Freeze Frame:
Fault Status: 11111100
Fault Priority: 1
Fault Frequency: 5
Reset counter: 72
Mileage: 292224 km
Time Indication: 0
Date: 2016.03.25
Time: 13:24:43

Freeze Frame:
Voltage: 12.42 V
Count: 86
How can this happen? should I code the battery again? or is some wireing issues because I checked around the parking brake and everything was fine.

Mister Bally

Moving parts fail.All of them, eventually. Ones that are in extreme environments (exterior of vehicle, in rain, snow and ice, heat) fail sooner.