5000TQ center driveshaft bearing replacement photos
#1
AudiWorld Super User
Thread Starter
Join Date: Jan 2003
Location: Fort Lauderdale, Florida
Posts: 2,644
Likes: 0
Received 0 Likes
on
0 Posts
5000TQ center driveshaft bearing replacement photos
I haven't been on this forum in years, mainly because I no longer drive my 5000TQ, but today, while looking through old photos, I came upon photos from 2009 that illustrate a few stages in the replacement of my 1988 5000TQ's center driveshaft bearing. I'm not sure that I ever knew exactly which bearing was supplied by eBay seller snolvr8, but I *think* that it was from a Mercedes-Benz 240D. As you can see, its outer diameter is a little smaller than the 5000TQ's bearing, but its inner diameter is a perfect fit for the driveshaft. After installation, there was a tad bit of rubbing, but it soon stopped and ran smoothly.
I created a new photo album, which I've labeled "5000TQ Center driveshaft replacement". I hope that these photos may help someone. And they remind me to again thank Jason at Autobahn Performance in Fort Lauderdale. He'd performed this operation on other cars and showed me how it's done. I'd have been lost without him.
Best regards to all,
Russ
5000TQ Center driveshaft replacement by RussB | AudiWorld.com
I created a new photo album, which I've labeled "5000TQ Center driveshaft replacement". I hope that these photos may help someone. And they remind me to again thank Jason at Autobahn Performance in Fort Lauderdale. He'd performed this operation on other cars and showed me how it's done. I'd have been lost without him.
Best regards to all,
Russ
5000TQ Center driveshaft replacement by RussB | AudiWorld.com
Last edited by RussB; 02-22-2015 at 09:01 AM.
Thread
Thread Starter
Forum
Replies
Last Post
hgoodman
Audi 4000 / Coupe GT Discussion
3
01-19-2009 02:00 PM
charles 200TQ
Audi 5000 / 200 / V8 Discussion
2
09-10-2007 05:17 AM
ShadowofBob
Audi 90 / 80 / Coupe quattro / Cabriolet
0
05-14-2007 05:11 PM
SteveAngry
Audi 5000 / 200 / V8 Discussion
0
06-12-2003 02:53 PM