87 5000SQ Throttlebody rebuild
#1
Audiworld Junior Member
Thread Starter
Join Date: Dec 2016
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
87 5000SQ Throttlebody rebuild
Has anyone ever rebuilt one of these. Where can you get the bearings. I've searched for the INA F96748 bearings to no avail on the net. I've attempted to use suitably sized o-rings in place of the crumbling seals but they are simply too tight and the throttle plate shafts do not return to the fully shut position without assistance.
Shokan wants $145 for a used unit that will probably need rebuilding too. The idle microswitch on mine shot and I broke the crap out of it trying to get it apart so I'm going to need a new idle/wot switch combo for it.
Any assistance would be greatly appreciated. I've almost finished rebuilding the engine so it will be brand spanking new after running for 278K miles over the past 30 years. I hope to get her back on the road this spring sometime.
Thanks,
Dave
Shokan wants $145 for a used unit that will probably need rebuilding too. The idle microswitch on mine shot and I broke the crap out of it trying to get it apart so I'm going to need a new idle/wot switch combo for it.
Any assistance would be greatly appreciated. I've almost finished rebuilding the engine so it will be brand spanking new after running for 278K miles over the past 30 years. I hope to get her back on the road this spring sometime.
Thanks,
Dave
Thread
Thread Starter
Forum
Replies
Last Post
PartyBoyRacing
Audi 90 / 80 / Coupe quattro / Cabriolet
0
07-27-2008 04:18 PM
Luxus Panzer
12v V6 Discussion
1
12-18-2007 12:49 PM