hevnsnt

Can you post the stl?

ArvX147

Looks like 10 deg angle? nice work - going to make one for my phone (note 8)

MH62

Yes, but are you going to resize it for your phone? I used SketchUp so the skp file may be easier to start from. I am not familiar with STL editors. Let me know.

MH62

9 degree. FYI, the highlighted face rests against the small lip under the armrest and the closest mounting screws are centered 1.87cm away. Any closer and they will interfere with the armrest sliding mechanism unless you use really short screw.

hevnsnt

Yeah I can modify for my phone, would appreciate the head start! Whatever you can share would be fine, I can figure out how to get it into my editor/slicer. Thanks!

MH62

The final version has some rounded edges and SketchUp models can be a pain to modify when corners are not square so I have a model with square edges and one with rounded edges. Unfortunately, the SketchUp files each exceed the 5MB limit on this forum so PM me with your email address and I can send them to you. For now, here are the STL files. Enjoy.

thebobmannh

Just want to really thank you for this, had this printed up for my Pixel 3 in my 2019 S3 and it is a perfect solution. My case was a little bigger than yours so I had to spend a few minutes with the Dremel to make things fit just right but still, thanks.

MH62

You're welcome, enjoy!

mobidutch

WANT! Someone should start selling these. Nice work!

MH62

Too many phone sizes and dimensions.