Misery
#1
Misery
<center><img src="http://img.photobucket.com/albums/v673/Rosati/TBwentwrong.jpg"></center><p>
Learning lessons sucks.
The intake valves were bent sideways
The exhaust valves came unseated and are stuck open
These pics were taked before the head and/block had a once over so its pretty dirty
The cylinder heads came pretty clean and the deposits were cleaned up pretty well w/ the cloth and dont look as bad now. But cyl 1 has 2 small scratches on the cyl head and im worried i did it by accident
The head is at the shop and im waiting on the valves to come in , will be pickin up valve seals tom.
Cylinder walls are in pretty good condition
Learning lessons sucks.
The intake valves were bent sideways
The exhaust valves came unseated and are stuck open
These pics were taked before the head and/block had a once over so its pretty dirty
The cylinder heads came pretty clean and the deposits were cleaned up pretty well w/ the cloth and dont look as bad now. But cyl 1 has 2 small scratches on the cyl head and im worried i did it by accident
The head is at the shop and im waiting on the valves to come in , will be pickin up valve seals tom.
Cylinder walls are in pretty good condition
#4
Did a TB job and fouled it up by going too fast and not realizing that my engine never came w/ a
secondary roller, the idiot that did the TB before me never put it back in, but i didnt catch it, so how smart does that make me? hmmmmm
So the TB was rubbing up against the damper the whole time and i installed it that way again! , this time there wasnt enough tension and the belt advanced timing and bent the valves.
So the TB was rubbing up against the damper the whole time and i installed it that way again! , this time there wasnt enough tension and the belt advanced timing and bent the valves.
Thread
Thread Starter
Forum
Replies
Last Post
qfrog Ti20
A4 (B5 Platform) Discussion
12
04-23-2005 06:23 PM