Mark this thread as Unsold
Audi A8 2000 A8L part out
05-03-2018, 11:05 AM
#1
AudiWorld Member
Thread Starter
2000 A8 part out
Picking up a 2000 black on black A8 tomorow with busted tranny that i will be parting.
Everything will be for sale so let me know what you need.
Pics when it gets here.
Everything will be for sale so let me know what you need.
Pics when it gets here.
Last edited by 90SQ; 05-05-2018 at 09:09 AM.
05-13-2018, 07:56 AM
#2
09-08-2018, 11:50 AM
#5
Audiworld Junior Member
Join Date: Sep 2018
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
I've got a 2003 S8 that needs:
- foam insulation panel for inside of driver's door (goes between inside door panel and inside of door (not the smaller insulation piece which goes over the window switch area) I assume it would look something like this:
https://www.ebay.com/itm/02-Audi-A6-...1/192631393863
but the original was not on the car when I bought it.
- might also need the foam insulation panel for the front right door
- trunk upper right plastic trim panel - for above battery access door in the trunk. Goes above the "felt" side panel and below the right side of the trunk edge gasket, and curves down at the back to meet the trunk's threshold. Held on by "industrial" velcro and a couple of plastic plugs.
Part of the trim panel is shown in the upper right of this photo:
http://members.tccoa.com/greenbird/A...ery/height.jpg
- two hold down nuts for trunk mat. From one photo I found, these are more like plugs than nuts.
- one of plastic studs which hold the driver's floor mat from slipping
- trunk gasket
- front battery hold down. Not sure exactly what is missing - there is a rear bracket that's removable, and a permanently mounted bracket above the front end of the battery which doesn't reach down to the battery itself. It may just be that the replacement battery doesn't have the shape the OEM battery had to use the hold downs. The photo of an S8 battery here appears to show the front bracket holding the battery in place:
https://forums.quattroworld.com/a8/threads/2154.phtml
One UK site shows this part, which could be the front hold down:
http://images.a8parts.co.uk/parts/4121.jpg
- "L" connector for battery vent tube.
Shown in red box in photo of 1997 A8 battery in the link above
(https://forums.quattroworld.com/a8/threads/2154.phtml)
- driver's and passenger door window switch bezels
- front cigarette lighter
Thanks.
- All41
- foam insulation panel for inside of driver's door (goes between inside door panel and inside of door (not the smaller insulation piece which goes over the window switch area) I assume it would look something like this:
https://www.ebay.com/itm/02-Audi-A6-...1/192631393863
but the original was not on the car when I bought it.
- might also need the foam insulation panel for the front right door
- trunk upper right plastic trim panel - for above battery access door in the trunk. Goes above the "felt" side panel and below the right side of the trunk edge gasket, and curves down at the back to meet the trunk's threshold. Held on by "industrial" velcro and a couple of plastic plugs.
Part of the trim panel is shown in the upper right of this photo:
http://members.tccoa.com/greenbird/A...ery/height.jpg
- two hold down nuts for trunk mat. From one photo I found, these are more like plugs than nuts.
- one of plastic studs which hold the driver's floor mat from slipping
- trunk gasket
- front battery hold down. Not sure exactly what is missing - there is a rear bracket that's removable, and a permanently mounted bracket above the front end of the battery which doesn't reach down to the battery itself. It may just be that the replacement battery doesn't have the shape the OEM battery had to use the hold downs. The photo of an S8 battery here appears to show the front bracket holding the battery in place:
https://forums.quattroworld.com/a8/threads/2154.phtml
One UK site shows this part, which could be the front hold down:
http://images.a8parts.co.uk/parts/4121.jpg
- "L" connector for battery vent tube.
Shown in red box in photo of 1997 A8 battery in the link above
(https://forums.quattroworld.com/a8/threads/2154.phtml)
- driver's and passenger door window switch bezels
- front cigarette lighter
Thanks.
- All41
09-09-2018, 07:05 AM
#6
AudiWorld Member
Thread Starter
I've got a 2003 S8 that needs:
- foam insulation panel for inside of driver's door (goes between inside door panel and inside of door (not the smaller insulation piece which goes over the window switch area) I assume it would look something like this:
https://www.ebay.com/itm/02-Audi-A6-...1/192631393863
but the original was not on the car when I bought it.
- might also need the foam insulation panel for the front right door
- trunk upper right plastic trim panel - for above battery access door in the trunk. Goes above the "felt" side panel and below the right side of the trunk edge gasket, and curves down at the back to meet the trunk's threshold. Held on by "industrial" velcro and a couple of plastic plugs.
Part of the trim panel is shown in the upper right of this photo:
http://members.tccoa.com/greenbird/A...ery/height.jpg
- two hold down nuts for trunk mat. From one photo I found, these are more like plugs than nuts.
- one of plastic studs which hold the driver's floor mat from slipping
- trunk gasket
- front battery hold down. Not sure exactly what is missing - there is a rear bracket that's removable, and a permanently mounted bracket above the front end of the battery which doesn't reach down to the battery itself. It may just be that the replacement battery doesn't have the shape the OEM battery had to use the hold downs. The photo of an S8 battery here appears to show the front bracket holding the battery in place:
https://forums.quattroworld.com/a8/threads/2154.phtml
One UK site shows this part, which could be the front hold down:
http://images.a8parts.co.uk/parts/4121.jpg
- "L" connector for battery vent tube.
Shown in red box in photo of 1997 A8 battery in the link above
(https://forums.quattroworld.com/a8/threads/2154.phtml)
- driver's and passenger door window switch bezels
- front cigarette lighter
Thanks.
- All41
- foam insulation panel for inside of driver's door (goes between inside door panel and inside of door (not the smaller insulation piece which goes over the window switch area) I assume it would look something like this:
https://www.ebay.com/itm/02-Audi-A6-...1/192631393863
but the original was not on the car when I bought it.
- might also need the foam insulation panel for the front right door
- trunk upper right plastic trim panel - for above battery access door in the trunk. Goes above the "felt" side panel and below the right side of the trunk edge gasket, and curves down at the back to meet the trunk's threshold. Held on by "industrial" velcro and a couple of plastic plugs.
Part of the trim panel is shown in the upper right of this photo:
http://members.tccoa.com/greenbird/A...ery/height.jpg
- two hold down nuts for trunk mat. From one photo I found, these are more like plugs than nuts.
- one of plastic studs which hold the driver's floor mat from slipping
- trunk gasket
- front battery hold down. Not sure exactly what is missing - there is a rear bracket that's removable, and a permanently mounted bracket above the front end of the battery which doesn't reach down to the battery itself. It may just be that the replacement battery doesn't have the shape the OEM battery had to use the hold downs. The photo of an S8 battery here appears to show the front bracket holding the battery in place:
https://forums.quattroworld.com/a8/threads/2154.phtml
One UK site shows this part, which could be the front hold down:
http://images.a8parts.co.uk/parts/4121.jpg
- "L" connector for battery vent tube.
Shown in red box in photo of 1997 A8 battery in the link above
(https://forums.quattroworld.com/a8/threads/2154.phtml)
- driver's and passenger door window switch bezels
- front cigarette lighter
Thanks.
- All41
Hi,
i have:
-cig lighter
-2 carpet studs
-front door switch bezels but they are from A8 so not soft touch like the S8, they're wood trims.
09-09-2018, 08:16 AM
#7
Audiworld Junior Member
Join Date: Sep 2018
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Would be interested in all of these. The soft touch paint on the switch bezels is scratched and tacky, and so far I've not found an easy way to repair them. Could you send me a PM with prices? Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
hanilanzi
A8 / S8 (D2 Platform) Discussion
5
03-17-2013 10:44 AM