any tig welders here? know how to stop this....
#1
any tig welders here? know how to stop this....
you weld pipe to a flange from outside of the pipe. when you look inside of the pipe, you get these "pimples" along the lines where the tig went through from outside.
sorry there is no pic. anyone who had similar incident know how to get rid of these "pimples"?
i am thinking maybe i am running too much heat and since the pipe is 18gauge... i don't mind these along the exhaust pipes, but definitly not on the intake pipes.
gimme some feedbacks if anyone knows what i am talking about.
thx.
sorry there is no pic. anyone who had similar incident know how to get rid of these "pimples"?
i am thinking maybe i am running too much heat and since the pipe is 18gauge... i don't mind these along the exhaust pipes, but definitly not on the intake pipes.
gimme some feedbacks if anyone knows what i am talking about.
thx.
#2
You moving too slow
Once you get the puddle going you have to move at a pretty decent tick to keep the metal from getting molten all the way through. Just takes practice more than anything I think.
What kind of material? Al?
What kind of material? Al?
Thread
Thread Starter
Forum
Replies
Last Post
Detroit
S4 / RS4 (B5 Platform) Discussion
15
12-01-2008 06:45 AM
QGMika
Performance and Tuning
1
05-08-2003 09:59 PM