anyone have Automatic A4 with GIAC chip and K04 ? how fast?
04-28-2001, 08:26 PM
#2
New Member
Join Date: Jan 2001
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
K04 & GIAC on 2000 Tip..................more
I don't have exact timings, but crude measurements (stop watch) tell me the 0-60 times are around 6.5-7.0 seconds.
It is very fast, compared to the K03 w/chip.
The Dyno measurements showed 270 ftlbs Torque and around 220-230 HP. Garrett beleives this can be improved and is working on a chip revision based on the measurements taken by DynoSpot Racing. I will post more data when this new chip is installed and measured.
My next upgrades will be a extrude honed exhaust manifold (Neuspeed) and a racing CAT and downpipe (Evo Motorsports).
I beleive these two improvements will dramatically reduce turbo lag and also increase top end power by allowing better air flow. DynoSpot will take more measurements when these upgrades are in place and tweak the software, if necessary.
Email me if you have more questions.
It is very fast, compared to the K03 w/chip.
The Dyno measurements showed 270 ftlbs Torque and around 220-230 HP. Garrett beleives this can be improved and is working on a chip revision based on the measurements taken by DynoSpot Racing. I will post more data when this new chip is installed and measured.
My next upgrades will be a extrude honed exhaust manifold (Neuspeed) and a racing CAT and downpipe (Evo Motorsports).
I beleive these two improvements will dramatically reduce turbo lag and also increase top end power by allowing better air flow. DynoSpot will take more measurements when these upgrades are in place and tweak the software, if necessary.
Email me if you have more questions.
Thread
Thread Starter
Forum
Replies
Last Post
x chip. i was just pondering about this. how much hp do you think we can get with x chip and exhaust
EurôStyle
A4 (B5 Platform) Discussion
21
08-07-2002 09:32 PM
Dieselino (Jeff)
A4 (B6 Platform) Discussion
16
05-20-2002 11:15 AM
