NYstgIII

car sounds like ****, give it gas and the car is very sluggish. then tried to get into reverse and car stalled. so put in ko4 ecu an car runs fine. so i kept it under boost just to get home. Any ideas? could they have given me a DBW chip instead of a NON-DBW? also what year started DBW? Thanks in advance

Mat Indukts Lambos

Also, does throttle adaptation take place? you could also look at channel 62 to see if the ECU's looking for a gas pedal signal, indicating your suspicion of the dbw chip, although that's speculation, I'm not sure what exactly would happen if that were true....

Žob

Did you put the different resistor in your ECU? Stage 3 needs that for nondbw

NYstgIII

Resistor?

Gldnrkt(GT3076R)

I think you and me are in the same boat....I mash my foot to the floor and the car just dies.

NYstgIII

after i put the ko4 ecu in the car ran fine

NYstgIII

are you dbw or nondbw?

Žob

Thats your problem right there. You need to change a resistor on the ECU

NYstgIII

sorry if this question sounds dumb but what and where exactly is this resistor?

Shep 1.8T

I'd like to know more about this as well.