Okay, today I did an 87MM[ID] DTM straight pipe welded into a Forge/Milltek center resonated pipe...
#1
Okay, today I did an 87MM[ID] DTM straight pipe welded into a Forge/Milltek center resonated pipe...
It is awesome and not to loud at all. Throttle response is there like you wouldn't believe. It uses the driver side hanger and the original Forge rear clamp so I can switch back to Milltek can if I want (fat chance). Everything else was custom welded for $135.42 including cost of tip {I couldn't wait for the shipped in 100mm DTM res tip I was scoping out} . You can hear the whiz of the turbo spooling. Awesome and the last piece of "my posted fastest TT" thread. v (Without turbo change, of course) If the 180 rear panel has the same fit for the outlets as the 225 rear panel. I will be the ultimate snoozer TT. MUHAAHAAAHAAAA.
Thread
Thread Starter
Forum
Replies
Last Post
SprinTTer
TT (Mk1) Discussion
4
10-04-2004 01:52 PM
Pete @ Stratmosphere
TT (Mk1) Discussion
3
04-05-2001 07:09 AM