Applying SQ5 exhaust valve wiring harness and MMI control to Q5 3.0T
#1
AudiWorld Junior Member
Thread Starter
Applying SQ5 exhaust valve wiring harness and MMI control to Q5 3.0T
I swapped out the 3.0T resonators with a pair of same from SQ5 along with the SQ5 valence. I love the sound, buy my SO does not. Consequently, I am looking to obtain and install the wiring harness for SQ5 valved exhaust to the 3.0T so that we can choose to have the valves open or closed.
Does anyone know if this is feasible?
Does the harness hook up to the electronics in the rear of the car?
Would I be able to enable the feature in the MMI?
Worst case, I'll have to force the flaps to the closed position. I am hoping that if I apply power to the motors, I can get them to close and stay closed until I figure out a better solution.
I'd hate to have to revert to stock...
Does anyone know if this is feasible?
Does the harness hook up to the electronics in the rear of the car?
Would I be able to enable the feature in the MMI?
Worst case, I'll have to force the flaps to the closed position. I am hoping that if I apply power to the motors, I can get them to close and stay closed until I figure out a better solution.
I'd hate to have to revert to stock...
Thread
Thread Starter
Forum
Replies
Last Post
audis
Audi A5 / S5 / RS5 Coupe & Cabrio (B8)
8
08-29-2014 04:20 PM
norbolig
A8 / S8 (D3 Platform) Discussion
8
10-09-2013 06:38 AM
India Whiskey Charlie
S4 (B6 & B7 Platforms) Discussion
17
08-10-2004 08:06 AM