Those of you that have installed H&R springs
#1
Those of you that have installed H&R springs
I searched the archives but could not find any definite answer. How do you tell the top from the bottom? Can you actually install them upside down? I should clarify I can tell the front from the rear.
Thanks
Thanks
#3
I think they're upside down and backwards...
or was that just the ball joints... :P
Better take the '91 90 20v out of your sig... or do you have some explaining to do? I still have the pearl hood and B3 headlights...
have u seen the car in stealth mode yet?
<img src="http://pictureposter.audiworld.com/64957/b4-90-20vt-3.jpg">
Better take the '91 90 20v out of your sig... or do you have some explaining to do? I still have the pearl hood and B3 headlights...
have u seen the car in stealth mode yet?
<img src="http://pictureposter.audiworld.com/64957/b4-90-20vt-3.jpg">
#4
They can go either way...
I had mine installed with the "Dead" coils at top which I think put the Logos and writing upside down. I just felt that there was no need to have those coils become upsprung weight (however small it might be). If you use the top perch as a guide, you will notice that it fits on both the "Bottom" and "Top" of the coil.
#6
Thanks !
Yeah you are right! I finally got through to someone at H&R and they said to install them like you did with the dead coils at the top and lettering upside down and thats how mine are in.
Thread
Thread Starter
Forum
Replies
Last Post
BCris69
S4 (B6 & B7 Platforms) Discussion
1
05-27-2005 06:57 AM
TheSleeperS
S4 (B6 & B7 Platforms) Discussion
1
12-04-2004 06:49 AM
silber_m3
S4 / RS4 (B5 Platform) Discussion
0
01-02-2003 11:52 PM