Anyone here have a blitzsafe aux and a Nav+ RNS-D?
#1
Anyone here have a blitzsafe aux and a Nav+ RNS-D?
My Nav+ doesn't recognize a working Blitzsafe aux. adapter attached to the CD changer 13 pin.
The Nav+ is coded properly but the message on the screen shows "no cd changer"
Any thoughs?
Erik
The Nav+ is coded properly but the message on the screen shows "no cd changer"
Any thoughs?
Erik
#3
Yup, and you have to disconnect and reconnect the battery to reset the radio.
Sounds stupid, but I went through all my connections for a few minutes until I more carefully read the instructions. Seemed silly, but it worked.
Have your security code handy. Do a throttle body adaptation afterward, and you'll have to rest 1-touch windows.
Have your security code handy. Do a throttle body adaptation afterward, and you'll have to rest 1-touch windows.
#6
13 pin... Oh, you're doing the trunk mounted adapter? No grounding then.
A TBA is best done with a VAG-Com. Direction are on Ross-Tech's site, but in short go to Measuring Block 60 (I think... double check) and switch to Basic Settings. Hit Go and you'll see the throttle position readings change. It will be done when it reads OK. Don't touch the accelerator pedal.
If you don't have a VAG-Com, turn the key to the ON position without starting and without touching the accelerator. Leave it there for a minute -- you should hear a slight buzzing as it moves.
If you don't have a VAG-Com, turn the key to the ON position without starting and without touching the accelerator. Leave it there for a minute -- you should hear a slight buzzing as it moves.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Beater
A6 / S6 (C5 Platform) Discussion
3
11-27-2005 03:31 PM
German Driver
S4 (B6 & B7 Platforms) Discussion
1
09-12-2004 10:09 AM
Silver Spectre
VAG-COM Discussion
3
04-25-2003 06:13 AM