Anyone know the ID & OD of the ko3 inlet pipes as well as the ko4 inlets?
#6
I couldn't get my calipers to fit in far enough to measure past the machined step, but here goes
Inlet id ~ 1.9", machined out to 1.975" to accept intake pipe.
outlet id ~ 1.435" machined out to 1.748" to accept compressor hsg.
I ended up sticking a spoon in the inlets, marking the spoon where it stopped at the machined lip and measured that distance across the spoon.
outlet id ~ 1.435" machined out to 1.748" to accept compressor hsg.
I ended up sticking a spoon in the inlets, marking the spoon where it stopped at the machined lip and measured that distance across the spoon.
Thread
Thread Starter
Forum
Replies
Last Post
LI-S4
NY / NJ / CT Discussion
2
06-11-2006 04:33 PM