The rear of my Twin2 will not slide over the front. They are the same diameter....

Reply Subscribe

Thread Tools

Search this Thread

03-20-2003, 07:23 PM

MasterBlaster

AudiWorld Member

Thread Starter

Join Date: Feb 2003

Posts: 521

Likes: 0

Received 0 Likes on 0 Posts

The rear of my Twin2 will not slide over the front. They are the same diameter....

What am I doing wrong? There are slits in the front piece that have been sawed in, but the diameter is the same as the rear tubing.

Reply Like

03-20-2003, 07:37 PM

ed@4induktion.com

Former Vendor

Join Date: Mar 2001

Posts: 6,010

Likes: 0

Received 0 Likes on 0 Posts

they dont slide over each other...use the stock clamps per the directions

i was a little confused at first too, but its right there in the directions they give you.

Reply Like

03-20-2003, 08:18 PM

MasterBlaster

AudiWorld Member

Thread Starter

Join Date: Feb 2003

Posts: 521

Likes: 0

Received 0 Likes on 0 Posts

The stock clamps join the rear piece to the downpipes fine, its the two cat-back pieces that won't

Reply Like

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

rear headrest

s4bannana

S4 (B6 & B7 Platforms) Discussion

09-30-2004 07:11 PM

Just lowered my rear..

NvFlw

TT (Mk1) Discussion

09-05-2004 12:07 AM

20x10 front, 20x11 rear on D3 SWB!

houseofsound

A8 / S8 (D2 Platform) Discussion

08-02-2004 12:29 PM

Rear blinker is 1156, correct?

fenixxx

A4 (B6 Platform) Discussion

12-14-2003 06:25 PM

Compare rear visibility: Sedan vs. Avant . . . .

Alf Arkin

A4 (B5 Platform) Discussion

06-18-2001 11:05 AM

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
1 / 1
Next
Last