AudiWorld Forums - Search Results

Go Back  AudiWorld Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: drpancho
Showing results 1 to 25 of 77
Search took 0.03 seconds.
05-17-2019, 03:41 AM
Replies: 11
Views: 696
Posted By drpancho

Nice one

Nice one
05-15-2019, 01:39 AM
Replies: 11
Views: 696
Posted By drpancho

I would do a compression test, to rule out any...

I would do a compression test, to rule out any hardcore problems before spending more money.
04-15-2019, 05:19 AM
Replies: 1
Views: 350
Posted By drpancho

I THINK you need to recode the cluster and ECU ,...

I THINK you need to recode the cluster and ECU , short a relay , rewire the reverse lights and add the clutch switch information.
All assuming the swap is the same as for a B6. Search "DIY:...
04-04-2019, 04:26 AM
Replies: 2
Views: 315
Posted By drpancho

I think you can't put it like that . Because you...

I think you can't put it like that . Because you can have small or big leaks in the same spot .
However if it's losing liters in 45 minutes you must be able to actualy see where the big leak is...
02-21-2019, 01:52 AM
Replies: 8
Views: 705
Posted By drpancho

Great :) . Fast and free

Great :) .
Fast and free
02-18-2019, 04:44 AM
Replies: 6
Views: 700
Posted By drpancho

To be on the safe side remove plugs and inspect. ...

To be on the safe side remove plugs and inspect.
I had this kind of failure before and it was a rod that broke. Since I wasn't speeding there was no hole in the block, "only" smashed plugs and...
02-13-2019, 04:23 PM
Replies: 1
Views: 390
Posted By drpancho

That is consistent with a open stat. run the...

That is consistent with a open stat.
run the engine until 70deg if the radiator is warm than it should eliminate any doubt.

The fact that the temp raises with the engine turned off is due to the...
02-12-2019, 05:56 AM
Replies: 8
Views: 758
Posted By drpancho

Also it might be good to check the connections to...

Also it might be good to check the connections to the coils.
Maybe that would stop the ECU from turning fuel pump on .

https://www.youtube.com/watch?v=GxsqrZg-xy8
02-06-2019, 06:03 AM
Replies: 13
Views: 1,319
Posted By drpancho

Coming from the Alfa world I have seen this...

Coming from the Alfa world I have seen this behaviour, "but if i turn it off i can't start the car after i need to wait for the car to be cold." fixed by a new crankshaft position sensor.
But if...
01-15-2019, 03:43 AM
Replies: 5
Views: 723
Posted By drpancho

The broken bulb warning would probably be looking...

The broken bulb warning would probably be looking for an open circuit.

You must have a short; current still flows but doesn't reach the bulb because it finds a path with lower resistance.
If you...
01-10-2019, 03:21 AM
Replies: 10
Views: 1,195
Posted By drpancho

This is really smart .

This is really smart .
01-03-2019, 02:20 PM
Replies: 13
Views: 637
Posted By drpancho

I was, I had the front supported by an old tire,a...

I was, I had the front supported by an old tire,a small bench and some ropes to avoid stressing the lines.
01-03-2019, 11:21 AM
Replies: 13
Views: 637
Posted By drpancho

In the end i've freed up completely the driver...

In the end i've freed up completely the driver side and the passenger side remain attached by tranny lines and some others I didn't identify what remained connected.

Check the videos on my thread...
01-03-2019, 07:58 AM
Replies: 13
Views: 637
Posted By drpancho

I didn't remove those lines only the ones going...

I didn't remove those lines only the ones going to the engine.
I was not able to use the service position, my problem was to remove the crankshaft pulley. I was not able to do it in the service...
01-03-2019, 04:38 AM
Replies: 5
Views: 933
Posted By drpancho

The car is beautiful. Good luck in achieving the...

The car is beautiful. Good luck in achieving the 500hp from the 1.8, I would actually like to follow the build.
12-30-2018, 11:21 AM
Replies: 3
Views: 399
Posted By drpancho

I think that you can also have storage ...

I think that you can also have storage
4B0863267A

But there's an aftermarket usb connector.
98-04 A6 & 99-05 Allroad USB Power Panel version2 ? Cup ? Cut by Caschy...
12-30-2018, 05:36 AM
Replies: 2
Views: 372
Posted By drpancho

Not specific to the B6 , but in all my previous...

Not specific to the B6 , but in all my previous cars OEM headlights were always far superior to aftermarket.
What I would try to do would be to check the manufacturer and source directly instead of...
12-28-2018, 03:12 AM
Replies: 5
Views: 377
Posted By drpancho

This plug didn't work is smaller than needed.

This plug didn't work is smaller than needed.
12-28-2018, 03:01 AM
Replies: 4
Views: 695
Posted By drpancho

I'm on the hunt for a daily driver, so I might...

I'm on the hunt for a daily driver, so I might contribute in the near future.
Keep it alive, please :D
12-24-2018, 04:33 AM
Replies: 17
Views: 1,343
Posted By drpancho

Thanks for all the inputs . Merry Christmas to...

Thanks for all the inputs . Merry Christmas to you 😀
12-23-2018, 12:57 PM
Replies: 17
Views: 1,343
Posted By drpancho

So, I've started the car without issues. I've...

So, I've started the car without issues.
I've reved it till 4500rpm and no strange noises from valves hitting the pistons or similar.
Car idled for 1h and coolant temp quickly raised to 90c and oil...
12-23-2018, 09:46 AM
Replies: 17
Views: 1,343
Posted By drpancho

Bolts retorqued. Today was a good day,...

Bolts retorqued.
Today was a good day, auxiliary belt is in (and more).
I had to repair one of the covers that was broke. I just used a small soldering Iron to patch it . (To the right, near the...
12-22-2018, 03:33 PM
Replies: 17
Views: 1,343
Posted By drpancho

I torqued both to 15 I believe. I was following...

I torqued both to 15 I believe.
I was following Justin's video:
​https://youtu.be/notzLin4dVI

I will torque them down to 22 Nm
12-22-2018, 01:45 PM
Replies: 17
Views: 1,343
Posted By drpancho

Hi, timing belt is on finnaly. I had a really...

Hi, timing belt is on finnaly.
I had a really hard time compressing the new hydraulic tensioner . I had to use my jack because I was not having enough levarege or strength ☺ .
I expect to do the...
12-11-2018, 01:20 PM
Replies: 17
Views: 1,343
Posted By drpancho

Thanks for the reply George . I do agree with you...

Thanks for the reply George . I do agree with you and that would be my prefered approach. However 2 things are pressing me to finish this and cut non essencial work.

1. My daily driver was stolen...
Showing results 1 to 25 of 77
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.