AudiWorld Forums - Search Results

Go Back  AudiWorld Forums > Search Forums
Reload this Page >

Search Results

 
Search: Posts Made By: vtraudt
Showing results 1 to 25 of 500
Search took 0.09 seconds.
Forum: Q7 Discussion
07-01-2019, 08:57 AM
Replies: 10
Views: 656
Posted By vtraudt

Got it!

Got it!
Forum: Q7 Discussion
07-01-2019, 07:01 AM
Replies: 10
Views: 656
Posted By vtraudt

50 psi seems a LOT. I will try the factory...

50 psi seems a LOT.

I will try the factory settings listed for the newer Q7 that run that size, see how it rides.
Forum: Q7 Discussion
07-01-2019, 06:59 AM
Replies: 10
Views: 656
Posted By vtraudt

Max tire pressure on sidewall is useless info....

Max tire pressure on sidewall is useless info. NOT a car specific recommendation for tire pressure.
Forum: Q7 Discussion
07-01-2019, 05:44 AM
Replies: 10
Views: 656
Posted By vtraudt

Found this, saying 44/49 psi (f/r): ...

Found this, saying 44/49 psi (f/r):

https://www.crownacura.com/inventoryphotos/115/wa1dgafe4fd010659/ip/50.jpg?height=400
Forum: Q7 Discussion
07-01-2019, 05:40 AM
Replies: 10
Views: 656
Posted By vtraudt

Door jam does not show pressure for the 21"...

Door jam does not show pressure for the 21" option with 295/35R21 tires.
Forum: Q7 Discussion
06-30-2019, 07:26 AM
Replies: 10
Views: 656
Posted By vtraudt

Tire pressure OEM 21" wheels/tires

What is the recommended tire pressure for the OEM 21" wheels with 295/35R21 tires?
06-13-2019, 01:06 PM
Replies: 2
Views: 488
Posted By vtraudt

Your are right, its a 3.0!!!

Your are right, its a 3.0!!!
06-11-2019, 07:16 AM
Replies: 2
Views: 488
Posted By vtraudt

2006 A4 2.8 Cabrio - AC troubleshooting

In the process of troubleshooting the 3.0 V6 Cabrio AC system (not cold).
Checked low/high side pressure, but doesn't seem to 'take' refrigerant.
Put 12V to the compressor clutch, seems to be...
04-18-2019, 03:55 AM
Replies: 4
Views: 479
Posted By vtraudt

Scanned and found code in Centr Electr 2 module: ...

Scanned and found code in Centr Electr 2 module:

01797 - Power Steering Hydraulic Pressure Valve (N119/N315)

009 - Open or Short to Ground

----


Address 4F: Centr. Electr....
04-17-2019, 09:33 AM
Replies: 2
Views: 432
Posted By vtraudt

S8 - DIY steering rack replacement?

Anybody has link to steering rack replacement?
04-17-2019, 08:34 AM
Replies: 1
Views: 281
Posted By vtraudt

Found this code: 01797 - Power Steering...

Found this code:
01797 - Power Steering Hydraulic Pressure Valve (N119/N315) - 009 - Open or Short to Ground

Where is the N119 solenoid located on the 2007 S8 (V10 engine)?

DIY to change it? ...
04-17-2019, 05:47 AM
Replies: 1
Views: 281
Posted By vtraudt

S8 stiff steering

Is there a 'servotronic' on the S8 cars? Relay or fuse that might be bad?
Any tips to troubleshoot?
I will try if VAGcom shows a module for the steering.
04-17-2019, 04:40 AM
Replies: 4
Views: 479
Posted By vtraudt

2007 S6 - stiff power steering

Takes a LOT of effort to turn the steering wheel.
The C5 had a 'servotronic' power assist system using a relay (speed dependent). Is the C6 using a similar system? Is there are relay or fuse that...
04-14-2019, 09:21 AM
Replies: 11
Views: 14,638
Posted By vtraudt

Remove mirror from mount

The get the mirror itself off the mount, just pry out the ball from its socket?
Mine is broken, so the mirror just wobble in socket; there are 'just mirror' listings on ebay for a fraction of the...
02-28-2019, 03:33 AM
Replies: 12
Views: 21,346
Posted By vtraudt

I have low oil pressure warning light at idle...

I have low oil pressure warning light at idle with warm engine.
Replaced upper (oil filter) oil pressure switch.
Would like to replace the lower as well. Bought/ordered 2 times, but cannot get...
02-25-2019, 07:10 AM
Replies: 2
Views: 3,649
Posted By vtraudt

B7 ecu wiring diagram or ecu pinout

Need trace wires. Can't find ECU wiring diagram or ecu connector pinout.

Can someone post or link?
Or message?
02-25-2019, 06:57 AM
Replies: 0
Views: 241
Posted By vtraudt

2.0T ECU pinout

Anybody have the pinout for the B7 2.0T ECU ECM ?
02-22-2019, 04:57 AM
Replies: 0
Views: 174
Posted By vtraudt

Fuse or relay to kill ignition

My car is not shutting off with the ignition key.
While looking for DIY how to troubleshoot and change the lock, I am currently pulling the fuel pump relay. But don't like running the pumps dry...
02-21-2019, 06:15 AM
Replies: 0
Views: 213
Posted By vtraudt

B7 2.0T - MAF sensor wiring diagram

Can someone post the wiring diagram for the MAF sensor?
Need to trace pig tail at sensor back to ECU. Fighting supply voltage code, already swapped sensor.

Car side 3pins (other 2 are empty),...
02-15-2019, 05:44 AM
Replies: 0
Views: 318
Posted By vtraudt

B7 2.0T FSI quattro - slipping tranny - 'load signal' error

Tranny (normal 6 speed auto, not CVT) slips in forward and reverse.
Only code in tranny module:
006231 - Load Signal P1857 - 001 - Error Message from ECU
Ditto ABS module:
18265 - Load Signal...
01-13-2019, 05:48 AM
Replies: 0
Views: 253
Posted By vtraudt

2006 A3 - steering wheel with paddle shifters

I am trying to install a paddle shifter steering wheel on my 2006 non paddle A3 2.0T.

It appears the car side connector is just slightly different from the one used with the airbags/wheels of the...
Forum: Audi allroad
10-08-2018, 04:05 AM
Replies: 4
Views: 557
Posted By vtraudt

Not holding anymore without 'glue'. But not...

Not holding anymore without 'glue'.
But not sure what was holding it in place when new, so not sure what is worn out or missing now.
Forum: Audi allroad
10-05-2018, 04:18 AM
Replies: 4
Views: 557
Posted By vtraudt

I cleaned the groove (blade screwdriver, rag,...

I cleaned the groove (blade screwdriver, rag, alcohol) and the 'edge'.
I filled the groove with 100% silicone, and coated the 'edge' on the cover also in silicone.
With hood open, clamped/wedged...
Forum: Audi allroad
10-02-2018, 04:53 AM
Replies: 4
Views: 557
Posted By vtraudt

Windshield bottom seal

The seal at the bottom of the windshield is letting water through, runs into cabin air filter and floods passenger side.
How to re seal it?

The seal is created by a groove in the windshield...
10-02-2018, 04:31 AM
Replies: 1
Views: 966
Posted By vtraudt

Afterrun Coolant Pump - disconnect DIY

Can someone post or link to the connector that the dealer unplugs?
Its an hour drive for me, pretty much 1/2 day job. Want to unplug the pump myself (until parts become available in December...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.