Tech Article Title
|
Author
|
Date
|
Escort Passport 8500 X50 Custom
Install |
Valentin Berechet
|
2004 |
Push the cord out the other hole above (it will form a "U" going in one side
and out the other) then pull it along and push it under the headliner, down
along the A-pillar and along the dash.
Once you remove the fuse box cover (simply pops off), pull the wire that was
fed along the dash.
Reach behind the dash and push out the cover where the display will be
installed.
The display decal can be used as a template for drilling the necessary
holes.
Use a piece of tape to hold the template in position. Start with a smaller
drill bit and go larger as needed.
Half of the lighter plug will still need to be used to hold the circuit
board in place.
The corners need to be shaved as well as the bottom slightly. For this, I
used a large file.
[1] [2] [3] |