Resyncing remotes to car
1) stand next to car
2) unlock car
3) close all doors
4) put non-remote style key in
5) turn to accessory
6) put remote 1 in and lock door (leave in door)
7) allow remote 1 to rock back from the lock position (I think you leave it in this position)
8) hold unlock button down for 10 seconds
9) press unlock button once for remote 1
10) repeat #7 & #8 (don't change the remote in the door)
11) press unlock button twice for remote 2
12) repeat again for remote 3 if you have one
This is pretty darn close to the full set of directions. I have no reason to test it out (sorry). ;-)
I edited your instructions slightly:
1) stand next to car
2) unlock car
3) close all doors
4) put non-remote (valet) style key in ignition
5) turn to accessory
6) put remote 1 in and lock door (turn clockwise, doors lock, leave in door)
7) allow remote 1 to rock back from the lock position to straight up. leave it in this position.
8) hold unlock button down for 10 seconds
9) press unlock button once for remote 1
10) repeat #7 & #8 (I repeated step #6 also)
(LEAVE THAT REMOTE IN THE DOOR)
11) press unlock button twice on your second remote
12) repeat again for remote 3 if you have one
Trending Topics
Bringing Audi to Life for Audi Fans
3) doors need to be opened after unlocking and then closed again?
4) since the doors are closed, are you in the car or are you reaching in through open windows to put valet key in the ignition?
10) this is for key #2? Doesn't state.
Thanks!


