Reading codes...
Thread Starter
AudiWorld Expert
Joined: Jan 2005
Posts: 34,682
Likes: 0
Reading codes...
Ok, so I read up on how to read codes, but I never get a "0000" at the end.. I just get "2331" over and over again with 1 solid flash in between. I'm pretty sure that's it, and I'm going to clear 'em to make sure since I just had my exhaust leak fixed (pre-Cat, pass. side).
Anyhow, just wanted to make sure I wasn't missing anything.
Anyhow, just wanted to make sure I wasn't missing anything.
Tech Guru
Joined: Oct 2002
Posts: 34,430
Likes: 130
You might be missing something.
If you are using a jumper read codes, you must re-connect the jumper for 4 seconds to get the next code. It will flash the same code over and over until you connect the jumper again to get it to move on.
Thread
Thread Starter
Forum
Replies
Last Post
Togglehead
A4 (B5 Platform) Discussion
5
Sep 21, 2007 01:08 PM
TToro 3.2
A4 (B6 Platform) Discussion
0
Nov 26, 2003 03:57 PM
