Found another split dust boot!!
#1
AudiWorld Super User
Thread Starter
Join Date: Oct 2001
Posts: 9,703
Likes: 0
Received 0 Likes
on
0 Posts
Found another split dust boot!!
The front lower control arm dust boot around the ball joint has torn....AGAIN!! Why do these damn things split so easily? Am I torquing down the nuts too tight! I'm using the Bentley Manuals torque setting? This is the third one up front I've found split after I've replaced it in June. Any tips on what I'm doing wrong? Or are the dust boots so s****ty from Audi?
#2
Doubt it is torque-related. Is it always the same boot or are you possibly discovering tears that were there before and went unnoticed?
Are you driving in extreme conditions? Offroad?
Maybe try the febi arms. I installed a set in '09 and all seals still intact.
Are you driving in extreme conditions? Offroad?
Maybe try the febi arms. I installed a set in '09 and all seals still intact.
Thread
Thread Starter
Forum
Replies
Last Post
Anyone have an old upper control arm laying around. I need the boot and clips that hold the boot on.
Scott Massey
A4 (B6 Platform) Discussion
0
06-22-2006 05:42 PM
Arcteryx::Stock Rods
S4 / RS4 (B5 Platform) Discussion
11
09-21-2004 11:08 AM