How do you do a TBA in a B6 and B5 A4 ?
#2
Re: How do you do a TBA in a B6 and B5 A4 ?
Throttle Body Adaptation:
Turn the key on but do not start the car.
[Select]
[01 - Engine]
[Measuring Blocks - 08]
Enter Group 060 (may be Group 098 on some cable-throttle cars)
[Go!]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. The TB
adaptation is being done as soon as you switch to basic settings. You will see the values change and hear the TB cycle for the first few seconds then it will stop. Leave it in basic mode for about 30 seconds, then switch back to normal settings and you're all set.
Be sure not to touch the accelerator and make sure the engine is NOT running when you do this!
Turn the key on but do not start the car.
[Select]
[01 - Engine]
[Measuring Blocks - 08]
Enter Group 060 (may be Group 098 on some cable-throttle cars)
[Go!]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. The TB
adaptation is being done as soon as you switch to basic settings. You will see the values change and hear the TB cycle for the first few seconds then it will stop. Leave it in basic mode for about 30 seconds, then switch back to normal settings and you're all set.
Be sure not to touch the accelerator and make sure the engine is NOT running when you do this!
__________________
Andy
Andy
Thread
Thread Starter
Forum
Replies
Last Post
ex-quattro PETE
A4 (B5 Platform) Discussion
8
06-25-2004 06:57 AM
RS41AB
A4 (B5 Platform) Discussion
4
04-11-2004 04:09 PM
CTA4AVANT
A4 (B5 Platform) Discussion
2
04-09-2004 01:37 PM
GDA4
A4 (B5 Platform) Discussion
6
12-13-2003 10:24 PM
1.8tScreemer
A4 (B5 Platform) Discussion
1
08-28-2003 03:53 PM