Will my Ross-Tech Twin-Com Interface work with a GM if I have the correct Software?
03-17-2003, 11:31 AM
#1
AudiWorld Super User
Thread Starter
Will my Ross-Tech Twin-Com Interface work with a GM if I have the correct Software?
I know Ross-Tech's software will not work but was wondering in there is software available that will work with the Twin-Com interface in a GM?
Thanks!
Thanks!
03-17-2003, 11:43 AM
#2
Audiworld Premium Sponsor
Join Date: Mar 2002
Posts: 1,907
Likes: 0
Received 0 Likes
on
0 Posts
No, see this page:
<ul><li><a href="http://www.ross-tech.com/vag-com/tour/obd-2.html">http://www.ross-tech.com/vag-com/tour/obd-2.html</a</li></ul>
__________________
Andy
Andy
03-17-2003, 12:01 PM
#4
Audiworld Premium Sponsor
Join Date: Mar 2002
Posts: 1,907
Likes: 0
Received 0 Likes
on
0 Posts
Did you read this section?
"There are three different hardware standards for OBD-II. Interface Adapters that work with VAG-COM only support one of these, ISO-9141. The ISO-9141 hardware layer is used by most OBD-II compatible cars produced world-wide except U.S. Ford and GM products. This test is useless on U.S. Ford or GM vehicles."<ul><li><a href="http://www.ross-tech.com/vag-com/tour/obd-2.html">http://www.ross-tech.com/vag-com/tour/obd-2.html</a</li></ul>
__________________
Andy
Andy
Thread
Thread Starter
Forum
Replies
Last Post
xkahn
A4 Cabriolet (B6 Platform) Discussion
8
02-08-2018 10:43 AM
CPLYONS
A8 / S8 (D3 Platform) Discussion
7
09-07-2015 07:19 PM
