Can someone pleases help with identifying this part
#1
Audiworld Junior Member
Thread Starter
Join Date: Dec 2003
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Can someone pleases help with identifying this part
In short, I set out the replace cam seals and valve cover gaskets. I was following the tech article in the resources section. However when I got to opening the 8 bolts for the valve cover; It seems this part (shown in picture below) protrudes on both driver and passenger side of the valve covers. This obstructs on the removal the valve covers. This part is not present on any of tech articles posted here even though the model is the same (01 2.7t a6) Well story short, I end up snapping this part in an effort to get more clearance and now I am Fu**ed. Can someone please tell me what this is and what is the part number of the cracked casting (visible in picture). Thanks. Also if possible please how to properly remove this part on the other side too.
#2
April Fools, maybe?
Part number is 078 131 166J, if I remember correctly. It's part of the SAI system. The valve in the end is the combi-valve. I don't have one on my car, but looks like you need to access and remove 3 bolts. If it's just the valve that's in the way, just remove that.
Part number is 078 131 166J, if I remember correctly. It's part of the SAI system. The valve in the end is the combi-valve. I don't have one on my car, but looks like you need to access and remove 3 bolts. If it's just the valve that's in the way, just remove that.
#6
Audiworld Junior Member
Thread Starter
Join Date: Dec 2003
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
The Red October
A4 (B6 Platform) Discussion
6
09-02-2008 05:18 PM
dec1184
Audi 4000 / Coupe GT Discussion
3
04-12-2006 01:21 PM