Intake?
Thread Starter
New Member
Joined: Jul 2003
Posts: 8
Likes: 0
Intake?
I am looking to port my 99 A6 2.8Q and have been told that if i port, i will need to upgrade the intake. I thought that Audi's sucked plenty of air already. Any advice appreciated.
Current Mods:
GIAC Engine and Tp chips
K&N
Current Mods:
GIAC Engine and Tp chips
K&N
AudiWorld Expert
Joined: Jun 2000
Posts: 29,356
Likes: 1
Normally...........
when the cylinder heads are ported, so are the other item which connect to those heads, to gain the full effect of the porting job! ;O)
Its a very good idea to port the intake manifold, to atleast "match" the larger ports of the heads.
Also every component upstream, & downstream can & should be modified, to handle the larger amounts of air, the heads could handle after their porting. ;O)
If all you do is port the heads, and nothing else, your gains will be small.
Its a very good idea to port the intake manifold, to atleast "match" the larger ports of the heads.
Also every component upstream, & downstream can & should be modified, to handle the larger amounts of air, the heads could handle after their porting. ;O)
If all you do is port the heads, and nothing else, your gains will be small.
Thread
Thread Starter
Forum
Replies
Last Post
Ninetyfive90Quattro
Audi 90 / 80 / Coupe quattro / Cabriolet
0
May 6, 2005 01:16 AM
chrisx706
A4 (B5 Platform) Discussion
0
Nov 29, 2004 02:46 PM
