Ground Clearance Test Results
#1
AudiWorld Member
Thread Starter
Ground Clearance Test Results
One of the reasons I purchased a 2018 Q7 was for the ground clearance. I occasionally go off-road and feel better knowing I can raise the car frame a little to avoid obstacles. I made a video of my “unscientific” test. Essentially when put in the Offroad mode, the car raises 2.25 inches above the Comfort mode or 2.75 inches above the Sport mode. FMMV
Last edited by rich2parry; 11-07-2017 at 11:52 AM.
#2
AudiWorld Member
Thanks for sharing. It was interesting to see the tire rotating forward, more so when the rear of the vehicle was adjusting. Per the brochure below your numbers are pretty accurate.
#3
AudiWorld Member
Thread Starter
Trevor,
It never occurred to me to look in the manual for the ground clearance specs, it would have saved me a lot of time, but I learned a lot and it was kind of neat to watch.
Rich
It never occurred to me to look in the manual for the ground clearance specs, it would have saved me a lot of time, but I learned a lot and it was kind of neat to watch.
Rich
#5
AudiWorld Member
Thread Starter
Trevor,
You are correct, my test really was about "movement" of the car frame rather than ground clearance. Your information is more useful. Once again, I should have looked in the manual.
Thanks,
Rich
You are correct, my test really was about "movement" of the car frame rather than ground clearance. Your information is more useful. Once again, I should have looked in the manual.
Thanks,
Rich
Trending Topics
#8
AudiWorld Member
Thread Starter
I put the video back online, link is below. I didn't think the video was that good and found that most of the information I wanted was in the manual. I'll keep the link active for a week which should give you time to video.
Rich
Rich
#10
AudiWorld Senior Member
Thanks for doing that testing.
Thread
Thread Starter
Forum
Replies
Last Post
CrazyINP-12V Ivan
A4 (B5 Platform) Discussion
0
04-06-2001 01:26 PM
I CAN'T believe that in the US you DON'T have to re-take your test if you only passed in an automati
Alan
S4 / RS4 (B5 Platform) Discussion
6
11-29-1999 05:55 PM