Hall effect sender...
Thread Starter
AudiWorld Senior Member
Joined: Sep 2006
Posts: 1,893
Likes: 0
Hall effect sender...
So after the bellhousing sensors were replaced....all functioned fine....MOST of the time. Car was left running for 2 hours, at idle, and the engine got nice and warm....this time it didnt start. Most of the time, it still did, but not this time.
After the first sensor replacment...no more codes were displayed....then after this no start, code 2113 came through...which i was told is the hall effect sender....is there a list of the codes somewhere on the net?
Also...can someone show me where i can aquire these parts? I look on autohausaz and couldnt find them...although i might not be looking for the right thing....is this a tough job?
After the first sensor replacment...no more codes were displayed....then after this no start, code 2113 came through...which i was told is the hall effect sender....is there a list of the codes somewhere on the net?
Also...can someone show me where i can aquire these parts? I look on autohausaz and couldnt find them...although i might not be looking for the right thing....is this a tough job?
Thread
Thread Starter
Forum
Replies
Last Post
Str4nger
Audi Original "S" Cars
2
May 13, 2007 01:13 PM
Josh S4
S4 / RS4 (B5 Platform) Discussion
0
Dec 15, 2003 04:05 PM
