Bending S6 wheels...... (seems this isn't the first thread about it)
#21
AudiWorld Super User
If it's not obvious, the only way to tell if a wheel is bent is to put it on a high speed balancer that has a runout gauge (Hunter) or slowly spinning it on a balancer while using a micrometer.
#23
2 wheels thus far for me... I would've said get forged wheels... but if you're blowing tires out then even forged wheels may not hold up...
In case you're looking for stock 19s I just commented on a post in the classified section. The guy is selling some 19s with blizzacks. He's in Rome, NY (not too far from NYC). Good guy and the wheels looked mint (tires are like new). I happened to buy the intake and exhaust in the post (hence I got a chance to peek at the wheels).
Good Luck and hope you figure out a solution.
In case you're looking for stock 19s I just commented on a post in the classified section. The guy is selling some 19s with blizzacks. He's in Rome, NY (not too far from NYC). Good guy and the wheels looked mint (tires are like new). I happened to buy the intake and exhaust in the post (hence I got a chance to peek at the wheels).
Good Luck and hope you figure out a solution.
Last edited by msaudiq5; 07-07-2016 at 06:27 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mexican Audi (Shane)
Florida Discussion
6
03-02-2007 08:44 AM
put in new suspension a few weeks ago, wheels will go on on thursday, allignment scheduled for the..
silver rain
A4 (B5 Platform) Discussion
1
05-05-2003 11:42 AM