received LWPSP yesterday & it's mounted...
04-02-2008, 08:51 AM
#1
AudiWorld Senior Member
Thread Starter
received LWPSP yesterday & it's mounted...
<center><img src="http://www.audifans.com/marketplace/images/pm_audifans_Parts.6786.amdickinson.0.jpg"></center><p>
...made only the newly machined holes a dull brush finish first (the above Fuchs look); & it just barely peeks through the OEM front cover. Picture perfect (photo to follow).
The original steel pulley is stamped "DE FT". It's Eff-Tee alright!
Learned lots about my tensioner & belt etc, never been there before.
Thanks very much sir!
...made only the newly machined holes a dull brush finish first (the above Fuchs look); & it just barely peeks through the OEM front cover. Picture perfect (photo to follow).
The original steel pulley is stamped "DE FT". It's Eff-Tee alright!
Learned lots about my tensioner & belt etc, never been there before.
Thanks very much sir!
04-24-2008, 10:46 AM
#5
AudiWorld Senior Member
Thread Starter
& thank you Catamount 90 for this photo...
<center><img src="http://pictureposter.audiworld.com/20695/tensioner_pulley.jpg"></center><p>...note the pin(?) (protruding near bottom left corner) in the new one, holding the swing arm in the retracted position. I used a slightly greased allen key to provide this pin's function during the re-install.
Thread
Thread Starter
Forum
Replies
Last Post
O.G.2
A4 (B7 Platform) Discussion
3
02-18-2021 07:23 AM
Monsoonenough
S4 (B8 Platform) Discussion
3
10-03-2015 02:59 PM