My Racetec strut bar hits the hood and master cylinder reservoir...
#1
AudiWorld Super User
Thread Starter
Join Date: Nov 2000
Posts: 6,270
Likes: 0
Received 0 Likes
on
0 Posts
My Racetec strut bar hits the hood and master cylinder reservoir...
anyone else have this problem?
It's installed, but theres a shiny spot where the hood hits, on the passenger side back bar.
It's installed, but theres a shiny spot where the hood hits, on the passenger side back bar.
#2
AudiWorld Senior Member
Join Date: Mar 2001
Location: Baltimore
Posts: 816
Likes: 0
Received 0 Likes
on
0 Posts
Re: My Racetec strut bar hits the hood and master cylinder reservoir...
Yep, I had the same problem until I removed the washers... The bar does contact my master cylinder reservior, but it just barely touches it.
#5
AudiWorld Super User
Thread Starter
Join Date: Nov 2000
Posts: 6,270
Likes: 0
Received 0 Likes
on
0 Posts
If I remove the washers, it will make the contact with the master cylinder worse....
The reservoir has a small dimple in it where the bar is contacting it.
I bet it's a good 1/8" at least.
I bet it's a good 1/8" at least.
Thread
Thread Starter
Forum
Replies
Last Post
16 Wins
Auto Detailing Discussion
2
05-31-2006 09:13 AM
Merkin
Audi 90 / 80 / Coupe quattro / Cabriolet
7
11-23-2005 10:46 AM
bpp
S4 (B6 & B7 Platforms) Discussion
2
08-31-2005 07:03 AM
blk18tq
A4 (B5 Platform) Discussion
1
03-11-2002 09:28 PM