people with 2001 and e-codes
#15
Yup thanks everyone...
but i'm getting two steps in the light pattern is this right? From what i remember my US housing had like a single long step like :
____
___/ but the e-codes are like:
__ ___
___/___/
is this right?? does this make sense to anyone?
____
___/ but the e-codes are like:
__ ___
___/___/
is this right?? does this make sense to anyone?
#16
Pattern is more pronounced w/ the E-codes.
looks like _____/_____/
To set them for alignment if not already done:
Pull up to a flat wall like a building .. close enough to nearly touch the bumper.
Turn on the lows and mark the exact center of where the beams hit the wall.
Measure down 3 inches and make a mark /\with tape or similar (the point clearly visible 25 feet away). Then back straight back 25 feet and adjust the beams so that the angle in each _____/ is aligned to the mark made in the prior step.
It helps to cover the light you are not adjusting with a towel. HTH
To set them for alignment if not already done:
Pull up to a flat wall like a building .. close enough to nearly touch the bumper.
Turn on the lows and mark the exact center of where the beams hit the wall.
Measure down 3 inches and make a mark /\with tape or similar (the point clearly visible 25 feet away). Then back straight back 25 feet and adjust the beams so that the angle in each _____/ is aligned to the mark made in the prior step.
It helps to cover the light you are not adjusting with a towel. HTH
Thread
Thread Starter
Forum
Replies
Last Post
CTA4AVANT
A4 (B5 Platform) Discussion
1
11-07-2007 03:23 PM
Holographic77
S4 / RS4 (B5 Platform) Discussion
3
09-13-2006 01:36 PM
SFS4'04
S4 (B6 & B7 Platforms) Discussion
1
06-15-2006 03:49 PM
MDM_A4 (Michael)
Florida Discussion
8
04-22-2005 05:29 PM
Wakeboarder_Boy
A4 (B5 Platform) Discussion
8
08-30-2002 07:34 AM