youngspeed

Been looking at the AWE site instructions and Bhvdr(a.geeks) write up on his Boost Gauge install. The Defi gauge has 4 wires, white for illum which connects to the blue/grey wire at the light switch, black for grounding. Up to this point, the install is similar to the AWE. For the other 2 wires, orange goes to the 12v wire for ignition on,red goes to the 12v battery wire. Can any body give advice on where the orange and red wires go to? TIA

919B6

then maybe the wires are for the sender? not positive, never installed an electronic gauge, but just my guess

youngspeed

yes it is. It is a new release but in 52mm instead of 60mm.

dagmz6s

like the cigarette lighter or another convenience item that is only on when the car is on.

diagnosticator1

2 wires for the back light, 2 wires to the boost pressure sensor /sender unit.