OBD11 coding help
Thread Starter
AudiWorld Newcomer
Joined: Nov 2018
Posts: 1
Likes: 0
OBD11 coding help
Hi, I have recently purchased an OBD11 and have used this device to change some functions on my B9 sline.
I have only been using the available credits as I am not familiar with coding but hopefully I will develop confidence in due time.
I have a couple of questions if anyone can help, firstly is there a way to switch off the lane assist easily after I have enabled this, I don’t have the button on the end of my indicator lever.
Secondly is there an easy way to code my boot lid to not open with the switch on the drivers door or remote when a trailer is attached, tow bar was not factory fitted and PFJones from Manchester did all the coding but the boot was missed and would prefer to carry this out myself.
I look forward to a response.
I have only been using the available credits as I am not familiar with coding but hopefully I will develop confidence in due time.
I have a couple of questions if anyone can help, firstly is there a way to switch off the lane assist easily after I have enabled this, I don’t have the button on the end of my indicator lever.
Secondly is there an easy way to code my boot lid to not open with the switch on the drivers door or remote when a trailer is attached, tow bar was not factory fitted and PFJones from Manchester did all the coding but the boot was missed and would prefer to carry this out myself.
I look forward to a response.
Thread
Thread Starter
Forum
Replies
Last Post
TaytoGuy
Audi A5 / S5 / RS5 (B9)
7
Feb 16, 2019 07:08 PM
brandonlowe
A8 / S8 (D2 Platform) Discussion
3
Feb 27, 2005 08:15 PM
