jaimpstera6

hello guys ,

I m trying to figure out how to properly bleed the air out of the cooling system !!! recently after replacing PCV, water pump , thermostat had to refill it with coolant - I think I might have some air in the system .
continue loosing coolant -

I can see the

Tube Assembly - Audi (06E-121-044-AE) might have bleeder set screws on the side - I can see the tail piece above this assembly leaking some..

any suggestions greatly appreciated.

Warhead

I don't see any bleeder screw on that part, make sure the new tube is installed correctly and that the O-rings didn't get messed up during the install.