Q5 mechatronic problem
11-27-2019, 06:18 PM
#1
AudiWorld Newcomer
Thread Starter
Join Date: Aug 2019
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Q5 mechatronic problem
Hi Guys,
Need some expert advice here for my 2010 (R8) Q5 2.0 TSFI: After a transmission fluid & filter exchange at 110K I got a one-off message on my dashboard "gearbox failure - ok to drive". The car is driving and shifting completely normal. So I had the error code read out, and there was one fault code stored for 'torque limitation due to clutch temperature'. There is also a code '001F68' present, which according to Audi indicates removal and replacement of the mechatronics control board.
Can anybody confirm that this makes any sense?
Cheers!
kai
Need some expert advice here for my 2010 (R8) Q5 2.0 TSFI: After a transmission fluid & filter exchange at 110K I got a one-off message on my dashboard "gearbox failure - ok to drive". The car is driving and shifting completely normal. So I had the error code read out, and there was one fault code stored for 'torque limitation due to clutch temperature'. There is also a code '001F68' present, which according to Audi indicates removal and replacement of the mechatronics control board.
Can anybody confirm that this makes any sense?
Cheers!
kai
Thread
Thread Starter
Forum
Replies
Last Post
Todd Beaulieu
Audi allroad
3
09-19-2012 12:35 PM
Pchelka01
A8 / S8 (D2 Platform) Discussion
4
08-05-2011 02:58 PM
Justin:NorCal
S4 / RS4 (B5 Platform) Discussion
0
12-20-2005 11:53 AM