DrV

Nice! Did you prep the plastic by rubbing it with alcohol to achieve optimal bonding?
I'm waiting for mine to arrive, ordered 6 days ago, but apparently Canadian orders take longer.

ukjeeper21

Yup and I used a hair dryer to heat up the adhesive in order to get a better bond...so far so good.

abacon09

Turned out better than I thought. I may have to get me some of these.

CrustyNoodle

Mine arrived a couple of days ago and I fitted them just today. I think they look great - I just hope they are going to stay put!

njbiker

looks great. mine arrived yesterday but will not have an opportunity to install until tuesday as i'm out of town. i'll post up some pics as well.

nelson

audirockz

My trim rings arrived yesterday too. I cleaned the area with alcohol, but had an issue with the 3M tape not sticking very well. I tried heating up with a hair dryer, as ukjeeper21 did, but they still didn't stick much at all. I ended up putting some clear silicone around the inside of the trim rings and then sticking them on.

I have them sitting overnight, with some masking tape holding them tightly in place. Will see how the look in the a.m. and try to take some pics.

Anyone else run into the same issue with the double-sided tape?

CrustyNoodle

I found the supplied tape to be a bit poor as well (it is branded 3M so you'd expect it to be a bit better than it was).
Mine have been attached now for over a day and it now feels like they are well stuck.

Ed@mtl

Thanks for the pics. Might get a set afterall.

audirockz

Here's a couple of pics, after the installation.

The clear silicone seems to have secured them much better than with just the not so sticky 3M tape.

njbiker

the pics look really good. amazing how such a little thing makes such an difference.

nelson