2006 Q7 power boot problem
#11
Cannot get new motor to fit
Hi guys
Replacing a 2014 Q7 J576 Boot lid unit.
Old unit is out. It had completely sheared on the pivot joint inside the unit!
New Unit just won’t seem to sit right enough to fully locate on the pins.
Any tips or tricks to get it to do so?
Ive removed a bracket for ease of access.
Thx
Mike
Replacing a 2014 Q7 J576 Boot lid unit.
Old unit is out. It had completely sheared on the pivot joint inside the unit!
New Unit just won’t seem to sit right enough to fully locate on the pins.
Any tips or tricks to get it to do so?
Ive removed a bracket for ease of access.
Thx
Mike
Thread
Thread Starter
Forum
Replies
Last Post