Anyone have a problem with the aftermarket exhaust melting the rear skirt housing?
#2
Anyone have a problem with the aftermarket exhaust melting the rear skirt housing?
I just installed my magnaflow 3" catback yesterday and today after a long hard canyon run at the So Cal event I noticed that it melted the paint and plastic on my rear skirt.
The muffler tip got so hot, that I guess it melted it off! Is this a defect of the muffler? Or do I have to cut the lip some so it doesnt get so close?
The muffler is a polished stainless steel 3" in and 2 2 1/2" out, with stainless steel tips. I have about 1 cm of clearance on each side of the tips! So they are very tight.
The muffler tip got so hot, that I guess it melted it off! Is this a defect of the muffler? Or do I have to cut the lip some so it doesnt get so close?
The muffler is a polished stainless steel 3" in and 2 2 1/2" out, with stainless steel tips. I have about 1 cm of clearance on each side of the tips! So they are very tight.
Thread
Thread Starter
Forum
Replies
Last Post
iProDrive
Audi 90 / 80 / Coupe quattro / Cabriolet
20
10-14-2008 09:23 PM
S40RCE:Smurf
NY / NJ / CT Discussion
4
09-02-2006 05:49 PM
USP
A4 (B6 Platform) Discussion
3
05-26-2005 08:57 AM