Noise From Febi Contol Arms When Hot
#24
I'm getting creaking from my drivers side front (sounds like the front lower CA) when it's over 75
degrees out. They've been on the car for about 25-30k. I had the ball joint on the pass. side front, lower CA fail recently too. I have a feeling the crap roads I drive on a daily basis, combined with stiff suspension kill CA's :-/
#26
i think there misinstalled ! the rubber bushing need to tighten in the normal position
of the car sitting on its wheels (suspension compressed). A LOT of installers and shops don't give a **** and just tighten them with the suspension fully extended putting the bushing WAY out of range of motion when the car is sitting on it's wheels .
#30
Are you suggesting that they should be not be torqued at ride height?
Not at ride height with suspension compressed? Wheels just hanging down?
The Bently manual and everyone I spoke to says to torque them at ride height with the suspension compressed.
The Bently manual and everyone I spoke to says to torque them at ride height with the suspension compressed.
Thread
Thread Starter
Forum
Replies
Last Post
eldoj
S4 / RS4 (B5 Platform) Discussion
17
08-25-2008 04:00 PM
jprescott
A8 / S8 (D3 Platform) Discussion
1
05-20-2008 06:44 AM